Maxi-Lift, Inc. introduces the new Maxi-Lift Easy-Core for PVC, Rubber, and Urethane belting

Dallas, TX, April 16, 2014: Maxi-Lift, Inc. introduces the new Maxi-Lift Easy-Core for PVC, Rubber, and Urethane belting. This new maximum duty belt core is up to 3X stronger than wood cores and can be used over-and-over again.

The Maxi-Lift Easy-Core sets a new precedent in belt core technology with greater strength, longer life, and easy installation all wrapped up in a single plastic core. Created from 100% recycled plastic, the Easy-Core is featured in a 6”x6” size and weighs 3.1lbs.

“Since we have been using these plastic cores in our belt shop, life has been much simpler. We have cut down considerably on our set up time and have been able to eliminate all of the dust and wood particles from the wood cores that cause extra mess and maintenance on our machines. Being able to re-use these parts has been a great way to cut back on cost as well.” Says Jeff Jowers, Maxi-Lift Belt Shop Manager.

The design features a through hole for use with a threaded shaft, dual locking studs, and a squaring line for precise belt alignment. The round corners in the receiver shaft ensure for easier slide in steel wind-up bar. In addition, the new Easy-Core is non-sparking, corrosion and moisture resistant, export approved, and is ideal for outside storage.

For more information, contact Maxi-Lift at 800-527-0657 or see our website at www.maxilift.com

*Patent Pending