Directions for Proper Elevator Bolt Torque on Belt

1. Maxi-Lift recommends the use of a cordless drill or impact driver that has an adjustable clutch system to manage torque. For a demonstration see our YouTube video at this link, or watch below.
2. Set the clutch mechanism to a lighter torque setting to begin.
3. Attempt to tighten the fasteners on the first bucket using this light torque setting. If this setting results in seating the bolt just flush into the back cover, then proceed. If it does not seat the head into the cover, or pulls it in too deeply, then adjust the clutch so the desired result is achieved. You are looking to just get the head flush into the cover.
4. Working left to right, repeat the process until you get a consistent result. Once you consistently get the bolt heads to seat, complete the remaining bucket installation, alternating the direction on each consecutive bucket to avoid causing the belt to bow out.
5. Do not overtighten the bolts, as this will cause high spots or humps between the bolts. These high spots will become wear points on the belt and will wear out before the rest of the belt.